832-492-5572Mon–Fri 8AM–5PM CT

American made · 24-hour turnaround available

Scraper Blades USAPrecision wear components.
Request a Quote

Our Work

A sample of parts recently through the shop. Every one of them started as a print, a sample, or a phone photo of a worn blade.

Need it fast? Ask about 24-hour turnaround

Recent work

Blades and wear parts off the mill

Machined polyethylene parts on a steel bench: two long drilled rails, a drilled wear bar, three small blades with a hole, a slot and a notch, and a flanged wear ring.
A single job on the bench — long drilled rails, a wear bar, three blade profiles and a wear ring.
Three thick white polyethylene blanks stacked and fanned on a steel bench.
Sheet blanks cut to length and stacked, square edges ready for drilling or slotting.
Three long slim white rails laid out on a bench with racks of sheet stock behind.
Long scraper rails cut from sheet, fixing holes down the centre line.
A thick white wear bar with four drilled holes resting across the T-slots of a machine table.
A drilled wear bar set down on the mill table, bevelled along its leading edge.
Three small white blades side by side showing a round hole, a vertical slot and a corner notch.
Three blade profiles from one job — round hole, vertical slot, corner notch.
A spread of white drilled and slotted bars with two navy cast nylon parts, one of them a curved segment.
A mixed run: drilled bars, slotted bars and two cast nylon parts including a curved segment.
Six thin white blade blanks fanned in a stack on a steel bench.
Thin blade blanks fanned after cutting, edges prepped to spec.
A single thick white wear bar with four drilled holes and a bevelled edge.
A thick wear bar with four through-holes and a bevelled leading edge.
Three small white blades angled on a bench in front of a machining centre.
Small replacement blades matched to the worn parts they replace.
A white wear ring with a drilled wear bar resting across it.
A wear ring and drilled wear bar from the same assembly.
A white machined wear ring with six bolt holes, seen from above on a steel bench.
A wear ring machined from solid, six bolt holes on a common pattern.
Three small white blades on a bench showing a round hole, a slotted cut-out and a corner notch.
Hole, slot and notch — three ways the same blank gets finished.

Every part here was made to order. Send us a drawing, a part number, or a photo of the worn blade and we’ll quote it.

Ready for a quote?

Tell us what you need and we’ll come back with a firm price and lead time.

Request a Quote
Call 832-492-5572